Asymmetric coherent rainbows induced by liquid convection*
Optimizing a left and right visual field biphasic stimulation paradigm fo...
Geometric wavefront dislocations of RKKY interaction in graphene
An Adaptive Clustering-Based Algorithm for Automatic Path Planning of Het...
Monolayer WS2 Lateral Homosuperlattices with Two-dimensional Periodic Loc...
Photonic-assisted radio frequency self-interference cancellation and freq...
Room-temperature Near-infrared Excitonic Lasing from Mechanically Exfolia...
A Filterless Photonic Approach for DFS and AOA Measurement Using a Push-P...
Encoder-X: Solving Unknown Coefficients Automatically in Polynomial Fitti...
Brain-Inspired Spiking Neural Network Using Superconducting Devices

A Micro-Force Measurement System Based on Lorentz Force Particle Analyzer for the Cleanliness Inspection of Metal Materials



Author(s): Zhang, TN (Zhang, Taonan); Liu, RC (Liu, Runcong); Yang, JL (Yang, Jinling); Wang, XD (Wang, Xiaodong)

Source: JOURNAL OF MICROELECTROMECHANICAL SYSTEMS DOI: 10.1109/JMEMS.2021.3129517 Early Access Date: NOV 2021

Abstract: In this paper, a MEMS micro-force measurement system based on Lorentz force particle analyzer (LFPA) principle is developed for the inspection of micro defects in or near the surface of metal materials. This system mainly consists of a small permanent magnet, a capacitive MEMS sensor and an interface circuit. The three parts convert a defect first into a force pulse, then a capacitive variance, and finally a voltage output. Experimental results show that this sensor system is capable to measure forces up to similar to 10 mu N with a resolution down to similar to 0.2 mu N, corresponding to defects with size of 0.5 similar to 2 mm. The amplitude of the obtained pulse signal increases with the enlargement of the defects volume, and the actual pulse waveform is consistent with the simulated pulse waveform. It demonstrates that the MEMS sensor can be the loadcell of LFPA to inspect micro defects in or near the surface of solid metals. This system is expected to be applied to the cleanliness inspection in metal sheet or foil. [2021-0116]

Accession Number: WOS:000733456200001

ISSN: 1057-7157

eISSN: 1941-0158

Full Text:


北京市海淀区清华东路甲35号(林大北路中段) 北京912信箱 (100083)




版权所有 中国科学院半导体研究所

备案号:,京ICP备05085259-1号 京公网安备110402500052 中国科学院半导体所声明